Guangzhou, China · Exported worldwide|WhatsApp|English
Technical Information

RMS, peak and programme power: what a rating actually means

Updated 23 Oct 2026 2 min read

Power handling is the specification most often compared and least often defined. The same driver can be described as 300 W, 600 W or 1200 W depending on which basis the seller used - and all three can be technically honest.

RMS / continuous

A long-duration rating, usually defined by a test signal and a time window. It represents heat: how much power the voice coil can dissipate before the adhesive or the former fails. When a datasheet says 300 W RMS, ask for the test signal and duration; without them the number is only comparable to the same manufacturer other products.

Peak

A short-term figure, often several times the continuous rating. It describes what the driver survives for a transient, not what it can sustain. Using peak as a planning number is the classic way to cook a high-frequency driver.

Programme / music power

A loosely defined middle ground, sometimes derived from measured pink-noise testing. Useful for comparing products from one supplier, unreliable across suppliers.

What to do with the numbers

Plan the system against the continuous rating. Leave headroom for the amplifier behaviour at clipping, and remember that the crossover point changes the thermal load: a high-frequency driver crossed lower sees much more energy than the same driver crossed at its recommended minimum.

Before you order

  • Ask which basis the rating uses, and against what signal.
  • Compare like with like: same basis, same crossover point.
  • If a value is not stated, treat it as unknown rather than assuming the optimistic reading.