Guangzhou, China · Exported worldwide|WhatsApp|English
Product Guides

Replacing a compression driver diaphragm: a checklist

Updated 23 Oct 2026 2 min read

Diaphragm replacement is routine in service work, and it is also where a lot of drivers are damaged a second time. The difference is usually preparation, not skill.

Record before you open it

Photograph the driver before disassembly: the terminal positions, the bolt pattern, the orientation of the diaphragm relative to the terminals. Note the model on the magnet label. If the diaphragm is already destroyed, the coil diameter is still measurable from the remains.

Match the right values

Three values decide fit: voice coil diameter, voice coil wire, and the mounting detail of the diaphragm assembly. Dome material affects the result but does not affect fit. Where the original part number is known, use it; where it is not, work from the driver datasheet rather than from appearance.

Clean the gap

Debris in the magnet gap is the most common cause of a second failure. Use tape or a soft probe - never a steel tool, which will be pulled into the gap and is very difficult to remove.

Centre and torque

Seat the diaphragm, tighten the screws evenly and in sequence, and check that the coil moves freely before applying power. A coil that rubs will fail quickly and the damage is not always obvious at low level.

Test before it goes back in service

Sweep at low level first. Listen for buzz at low frequencies, which usually means the coil is not centred. Check impedance against the datasheet.

Before you order

  • Driver model and diaphragm diameter.
  • Wire type and impedance.
  • Quantity, because service stock is usually bought in small batches.