How a compression driver is built
A compression driver is a small assembly doing a difficult job: converting electrical input into pressure at the throat of a horn. Understanding its parts makes specification conversations much shorter.
Diaphragm and voice coil
The diaphragm is the moving dome; the voice coil is bonded to it and sits in the magnet gap. These two parts set the upper limit of the driver. Diameter determines how much moving mass you can afford, and the wire and former decide how much heat the assembly survives.
Phase plug
Between the diaphragm and the throat sits the phase plug. Its job is to sum the pressure from the dome without letting path-length differences cancel at high frequency. The slot geometry is why two drivers with the same diaphragm can have very different high-frequency behaviour.
Magnet and gap
Ferrite or neodymium, with a top plate and pole piece shaping the gap. Field strength in the gap sets sensitivity; the gap geometry sets how much excursion is available before the coil leaves the field. Neodymium saves weight, which matters in flown arrays.
Throat
The exit diameter. It has to match the horn, both in diameter and in bolt pattern. A mismatch here loses output and can introduce leaks that are hard to diagnose later.
Before you order
- Throat diameter and mounting pattern for fit.
- Power handling and recommended crossover for safe operation.
- Sensitivity measured on the same basis if you are comparing drivers.