Guangzhou, China · Exported worldwide|WhatsApp|English
Voice Coil Knowledge

How to choose a voice coil for woofer rebuilds

Updated 23 Oct 2026 2 min read

Most rebuilds fail at the same three points: inside diameter measured wrong, former material chosen by habit, and power handling compared without a test basis.

Most voice coil replacements fail for one of three reasons: the inside diameter was measured on a swollen old coil, the former material was chosen by habit, or two power ratings were compared without knowing the test basis. This note covers the parameters that decide whether a replacement actually fits.

Inside diameter comes first

Measure the former, not the old coil. A coil that has been overheated expands and will read larger than it was when new — enough to make a 25.4 mm coil look like 25.6 mm.

ParameterHow to measureCommon error
Inside diameterAcross the former bore, at three pointsMeasuring a swollen old coil
Winding heightWound section only, not the formerIncluding the lead-out
Total heightFormer end to endAssuming it matches the old part

Former material decides heat path

Aluminium moves heat away from the winding faster than paper or Kapton, which matters in continuous use. Kapton tolerates higher temperatures but conducts less. The right choice depends on duty cycle, not on price.

If the original part used a paper former in a low-power application, replacing it with aluminium changes the thermal behaviour of the whole driver — not always for the better.

Winding: layers and wire

Four-layer windings put more copper in the same gap, raising Q and reducing efficiency. If the goal is a drop-in replacement, match the original layer count before optimising anything else.

Flat wire packs more copper into the gap; round wire is cheaper and more common in repair stock. The difference is measurable but small at low excursion.

Power handling needs a basis

A number without a test basis is not a specification. 600 W RMS, 600 W peak and 600 W program are three different coils. Ask which basis the supplier used before comparing two parts.

Ordering checklist

  • Inside diameter, measured on the former
  • Winding height and total height
  • Former material and wire type
  • Impedance, and whether it is nominal or measured
  • Power handling with its test basis

Products in this range

Related reading